06-05-2016 11:13 AM
Hi all
I have s170 work fine with wccp to ASA by M1 and P1
what is the advantage of using p2 ? and how i can use it
and can any one give me any config example or cvd of using p2 I didn't fine it at all
is P1 and P2 used to high viability ?
Is P2 should be in another sub net of P1 ?
or P1 should be used for in and P2 for out?
your help is highly appreciated
Solved! Go to Solution.
06-05-2016 07:40 PM
A useful case to use P1 and P2 is using P1 to receive incoming requests from internal users and use P2 accessing internet to get the response for all incoming requests.
Normally it is not recommended to use P2 to receive the incoming request. If you have to do so, you have to enable it via CLI command "advancedproxyconfig">miscellaneous as by default it is disabled.
Do you want proxy to listen on P2?
[N]>
Additionally P1 and P2 have to use the same routing table which is a restriction.
Hope it helps.
06-05-2016 07:40 PM
A useful case to use P1 and P2 is using P1 to receive incoming requests from internal users and use P2 accessing internet to get the response for all incoming requests.
Normally it is not recommended to use P2 to receive the incoming request. If you have to do so, you have to enable it via CLI command "advancedproxyconfig">miscellaneous as by default it is disabled.
Do you want proxy to listen on P2?
[N]>
Additionally P1 and P2 have to use the same routing table which is a restriction.
Hope it helps.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide