Yes, there is a better way to get the devices to be recognized again by Control Hub. In newer versions of Room OS, the devices will no longer prompt you to manually enter the provisioning server after the device reboots. Instead, you can use the following steps to re-register or re-link the devices back in Control Hub:
Delete the device from Control Hub.
Go to the device and choose a provisioning option, to kick off a provisioning reset.
The device will reboot and automatically re-register or re-link with Control Hub using the new provisioning server settings.
The device will then be available in Control Hub and you can re-personalize it to the new email address.
This is the preferred method for re-registering or re-linking devices in newer versions of Room OS. It is more efficient and reliable than the previous method of manually entering the provisioning server settings.
Here are some additional tips for re-registering or re-linking devices in Control Hub:
Make sure that the device is connected to the network and has a valid IP address.
Make sure that the device is not in provisioning mode.
If you are having trouble re-registering or re-linking the device, you can try resetting the device to factory defaults.
