Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1242
Views
0
Helpful
1
Replies

allow only MCS data rates and disable others

wg wireless
Level 1
Level 1

‎10-22-2013 02:57 PM - edited ‎07-04-2021 01:08 AM

Hi,

i have 1260 AP (Autonomous) and i want the clients to connect only at 5GHz MCS rates (802.11n) and i dont want clients connecting at 802.11a data rates. i tried to do this from AP GUI but it says i have to enable at least one data rate from 11a. Please advise how to acheive this.

Thanks

Labels:
0 Helpful
1 Reply 1

Stephen Rodriguez
Cisco Employee
Cisco Employee

‎10-22-2013 03:53 PM

you have to have a 'legacy' rate enabled at this time.  What I would do, is disable all rates except for 54Mbps.

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card