Can WLC 4402 support AIR-CAP1602E-S-K9?

[Ivan Teo]

Hi

I had 1 end of life WLC 4402 controller. Can it support AIR-CAP1602E-S-K9 access point? If cannot, what is the supported access points for WLC 4402.

Thanks

[Stephen Rodriguez]

The 4402 does not support the 1600 series AP.  The 1600 Series is first supported in 7.4 Code, an the 4400 can only run up to 7.0.

http://www.cisco.com/en/US/docs/wireless/controller/release/notes/crn7_0_240_0.html#wp784295

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

[Ivan Teo]

Hi Steve

Thanks for the reply. Another question if i use the below access point with smartnet and configure as standalone AP. But in future if I want to configure to lightweight AP, can i request the firmware from CISCO TAC to flash the AP and make it lightweight? Thanks

AIR-SAP1602E-S-K9

802.11a/g/n   Standalone AP, Ext Ant, S Reg Domain

[Stephen Rodriguez]

Yes, you can download the recovery image and convert it to work with a WLC.

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

[Leo Laohoo]

You don't need a valid Service Contract to download the RCV IOS anymore.

Sent from Cisco Technical Support Wii App