We faced issues with Cisco AnyConnect when trying to connect at home network. we have 2 scenario
Scenario 1: one home network and Cisco AnyConnect gives "limited or no connectivity" error message
Scenario 2: multiple networks and Cisco AnyConnect limits all networks speeds beside one who was connected from first time. (speedtest, signal), or even worst, we cannot connect at other SSID at all.
For all users, after disable Cisco AnyConnect activity worked well.
Messages History shows that Cisco AnyConnect stops in Acquiring IP address... or I had a situation where I had 2 networks, 2 different IP address classes and the second network remenders the IP address from previous network, even if the that networks should have different class IP address.
If user cannot connect to Cisco AnyConnect, user cannot connect to VPN after that.
Last Thursday (7/30/2020), our tier 1 Internet provider went offline due to severed fiber. After access was restored, we began receiving reports of users not being able to connect to the Internet via our corporate WiFi network; however, they could connect...
I have a Cisco Aironet 1300 2.4Ghz Wireless Bridge Access Point AIR-BR1310G-A-K9-R that is in LWAPP configuration. I would like to convert it back to Autonomous. I have downloaded the configuration for autonomous and placed it in the TFTP-Root...
Hi,I’m using a AIR-CAP3502I-A-K9 access point.Getting over 300 mbs on wired (ethernet) computers, but any device (phone or laptop) on wifi will get less than 100 mbs.Is there any way to speed up service on wifi devices?