download TFTPd32 from Google and install it on ur PC.. point the image that you have downloaded in the TFTP server..
connect a Ethernet cable between ur laptop and AP.. both should be in the same subnet.. and connect a console cable and get the hyperterminal console access and issue the command.. make sure you are able to ping the PC and the AP and vice versa!!
AP#debug lwapp console cli or debug capwap console cli
AP(confg)int fa 0
AP(confg-if)ip addr <addr> <mask> (same subnet as that of the laptop)
AP#archive download-sw /force-reload /overwrite tftp://<tftp ip address>/<image name.tar>
Hello. Have IW3702-2E with x4 AIR-ANT2568VG-N 2.5/5.0Ghz 6/8 dBi Omni antennas.AP is in autonomous mode ap3g2-k9w7-tar.153-3.JI4.tar. I have run several copy test`s;2.4ghz I can connect 144Mbit only, cause there is only 20Mhz mode avai...
Hello everybody,I have an issue where the captive portale won"t work properly, the problem is that I have control over the WLC only and not adipsys platform I think I did what should be done in the WLC following the official guide provided by adipsys...
I am a student at Pioneer Technology Center, Ponca City, Oklahoma. We have a Cisco 1950 Series wireless router that we wish to configure as a wireless hotspot. I am interested in how the router manages wireless connections and I would like to see a diagra...
Hello All, Having a very difficult time getting my 1702i AP to join WLC 2504. This is working fine when direct connected to PoE port on device, but when I attempt to connect to edge switchport (configured for same VLAN as AP-manager) the connec...
I am trying to setup evaluation licenses on a Catalyst 9800-CL appliance. I was told all you have to do was registered it under your Cisco smart account, and it will automatically activate the evaluation licenses for the appliance under your account. I re...