cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
740
Views
10
Helpful
0
Comments
Surendra BG
Cisco Employee
Cisco Employee

This Document shows us how to add the aIOS AP on to any NMS device what we have - WCS/NCS/PI

Config on the AP

==============

1>> Configure the Community on the AP with the Community Name With Read/Write (RW) permission

2>> Configure the SNMP host IP address with the community name

Here are the command for the same on the AP..

ap(config)#do sh run | i snmp
snmp-server community <community name> <access level - ro/rw>
snmp-server host <NCS/PI/WCS IP addr> <Community name>

Example

ap(config)#do sh run | i snmp
snmp-server community maibpi RW
snmp-server host 10.106.60.111 maibpi

Config on the PI/NCS/WCS

========================

1>> From the NCS GUI Go to COnfigure >> Access Points

2>> From the Drop Down, Select ADD Autonomoous AP

3>> Fill in the details and hit on ADD

4>> If Added Details are correct then this is how we see on ther PI GUI...

5>> If we click on the AP this is how it looks

TROUBLESHOOTING

===================

>> Just in case if we are failing to add APs,

1>> Make sure the config on the AP is correct and pointring to the right Community and the PI address

2>> Telnet / SSH credentials should be set same on both the AP and the NCS

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Quick Links