Create WCS templates from existing WLC controller?
One of my customers implemented a single WLC over a year ago.
They now want to expand with a second WLC and add WCS for management.
WCS is able to retrieve the current config from a controller which is a nice feature. But what i would like to do is use the config from the primary (existing) WLC, convert that into WCS templates, so i can push the templates to the new controller after initial setup.
If your running 126.96.36.199 or later, it's easier to just backup the config of your existing wlc and then open it in a text editor and change the ip address, host name, etc. then just upload that to the new wl after you get it configured.
Make sure you are running the same code on each wlc. Later code supports auto install feature, but if it's just one wlc, it's easier to just edit the file and upload it.
Hi, My customer wants to Download a report of users with MAC addresses who logged in June 2020. He is using PRTG but that Server is not connected with WLC. What we need to do to achieve this goal? Thanks in advance. Regards,Waqas
[ The link to the discussion will be published on November 10th ]
This event is an opportunity to discuss the LTE market trends from a consumer perspective, highlighting the 4G LTE service from Cisco Enterprise BU. Furthermore, we will discuss the strateg...
Hi All,We have 9100 AP trying to join on 9800 WLC. When AP try to join controller it gives below error Sending Join request to 172.16.31.66 through port 5254Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Join(5)Discarding msg CAPWAP...
Hello, I hope somebody has a solution for the issue I am facing. I have 2 WAP150's, both with firmware 188.8.131.52, and I am not able to save a specific change. Under Wireless > Radio > Advanced Settings > Legacy Rate Sets I can unselect ra...