Here is my task which does not seem so easy to accomplish:
My company is handing out Guest-WLAN access to our visitors. Every visitor has its individual username and password combination. Right now our LobbyAdmins use the NCS GUI to create these users. So far so good...but to make things easier and less time consuming I want to implement the following solution:
I will create a CSV file containing valid username and password combinations (problem: supposed to change on a daily basis so that returning visitors are required to obtain a new username/password combination upon their next visit). This file is to be imported into the NCS and the guest user accounts are then to be synced with the WLC5508 controllers. The bulk creation of guest users via the GUI (importing a CSV file) works just fine.However I would like to have an automatic process that will import these users e.g. daily at 6 a.m.
I'm stuck with the following tasks:
1. schedule the import via the csv file
2. schedule the synchronisation with the WLC controllers
[ The link to the discussion will be published on November 10th ]
This event is an opportunity to discuss the LTE market trends from a consumer perspective, highlighting the 4G LTE service from Cisco Enterprise BU. Furthermore, we will discuss the strateg...
Hi All,We have 9100 AP trying to join on 9800 WLC. When AP try to join controller it gives below error Sending Join request to 172.16.31.66 through port 5254Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Join(5)Discarding msg CAPWAP...
Hello, I hope somebody has a solution for the issue I am facing. I have 2 WAP150's, both with firmware 220.127.116.11, and I am not able to save a specific change. Under Wireless > Radio > Advanced Settings > Legacy Rate Sets I can unselect ra...
Hey Guys,I Have several 1600 Series AP's (AIR-CAP1602I-ZK9) that was working with WLC before, I changed them with 1800 series but would like to use 1600 Access Points series independently and without WLC for somewhere else, so I want to know do they...