I have deployed a cisco 2504 wireless controller along with four (04) lightweight access points (1041N) in four floors respectivly. The clients connect to the AP which is deployed in the lowest floor have regular timeouts/packet drops. Further this particular ap operates at channel 11 and it has around 11-13 rough access points in the same area and operates in channels such as 1,3,6,9,11. The DCA (dynamic channel allocation) is set to auto in the WLC. Further each ap has maximum of 07 -10 clients at any given time and I have changed this particular ap and checked still the result is same hence there is nothing wrong with the ap.
How can i troubleshoot this issue futher. Please advise.
Well if you can't eliminate the interference, there is not much you can do. The other AP's which you don't manage is out of your control and heck... I bet all the other users on their APs are having the same issue. This is why having an AP with a 5ghz radio goes a long way. You would have less interference on the 5ghz and your client probably would drop.
Hi, My customer wants to Download a report of users with MAC addresses who logged in June 2020. He is using PRTG but that Server is not connected with WLC. What we need to do to achieve this goal? Thanks in advance. Regards,Waqas
[ The link to the discussion will be published on November 10th ]
This event is an opportunity to discuss the LTE market trends from a consumer perspective, highlighting the 4G LTE service from Cisco Enterprise BU. Furthermore, we will discuss the strateg...
Hi All,We have 9100 AP trying to join on 9800 WLC. When AP try to join controller it gives below error Sending Join request to 172.16.31.66 through port 5254Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Join(5)Discarding msg CAPWAP...
Hello, I hope somebody has a solution for the issue I am facing. I have 2 WAP150's, both with firmware 184.108.40.206, and I am not able to save a specific change. Under Wireless > Radio > Advanced Settings > Legacy Rate Sets I can unselect ra...