cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
828
Views
0
Helpful
1
Replies

Aironet 1140 AP - Lost connection after updating duplex

HBI_Support
Level 1
Level 1

I change the duplex from Auto/Auto to Full/1000 via the attached screenshot setting in the web access console. Now the AP will not respond and allow items to connect to the AP. I can no longer access it via the URL or ping it. Any ideas on how to get it back?

Cisco AP.png

1 Accepted Solution

Accepted Solutions

Leo Laohoo
Hall of Fame
Hall of Fame

You will need to console into the AP change the settings back.  Make sure you leave speed and duplex to auto/auto.

View solution in original post

1 Reply 1

Leo Laohoo
Hall of Fame
Hall of Fame

You will need to console into the AP change the settings back.  Make sure you leave speed and duplex to auto/auto.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: