WAP 561 - Single Point Setup and Rogue AP Detection

[Christoph Franke]

On my LAN there are 3 Cisco WAP 561 APs running in a Single Point Setup. Do I need to mark all of them "Trusted AP" in the Rogue AP Detection also (meaning one of them having the respective other two marked)? Thanks in advance!

[slstratt]

Hello Christoph,

Thank you for using the Small Business Support Community!

After testing the single point setup feature on the WAP561, other members of its cluster will still appear in the Rogue AP Detection list, and will have to be added manually to the Trusted AP list. Please keep in mind that the Rogue AP feature does not impact security settings on any of the WAPs detected. However, a WAP with rogue AP detection enabled will periodically and briefly disconnect from all wireless clients to scan for APs.

If you have any other questions, please feel free to post them here and I will do my best to help!

Best,

Taylor

[Christoph Franke]

Hello Taylor,

thanks for your support! I manually forced the WAPs to trust each other. Maybe the documentation could be updated regarding the Singe Point Setup feature or an upcoming firmware release does that step automatically.

Best regards,

Christoph