02-17-2013 07:36 PM
Hi,
I have an old computer with dead wifi nc and I thought that bridging it with was121 should work, but can't find anywhere any comprehensive documentation on how to set it up. Any help,please?
Thanks
02-19-2013 06:19 AM
Hello Risa,
Not sure what you are trying to accomplish here. You would use the Workgroup bridge mode to Bridge the WAP121 to another wireless device like a Wireless router or a Access Point to extend your wired network.
If you want some documentation though go to this link below.
Hope this helps,
Thanks,
Clayton Sill
09-05-2013 12:24 PM
Hi Risa,
I can provide you an article that explains how to configure the work group bridge and all its details.
Refer article Configure Work Group Bridge on WAP121 and WAP321 Access Points
I hope this helps,
Thanks,
Naresh Arjunan
Please rate useful posts.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide