I have two buildings across the street from each other and purchased the WAP4410N on advice of a tech support rep at Cisco who stated I would be able to bridge the two locations with the WAP4410N and my current router WRT610N in N mode however todate 8 month later I've gotten no success in bridging in N but I've been successful in G, but the connection is spotty (not to mention VERY SLOW) as it's just out on the verge of being out of range. for the four tech's who've opened cases they agree this is possible but have been unable to get this to work in their lab or onsite here and close the case after they give up since there is at least A bridge irregardless of how poor of a job it's doing.
Has anyone been able to bridge in N mode? If so any advice as to the specific settings you have been able to use to connect? If not, or you can verify why not, what additional changes I will need to make.
and yes I am aware that running a line would be a better option, but it would be $3k to have the pipe just across the street let alone the burial quality cat5 costs
