05-19-2016 02:56 PM
I am trying to add 2 x WAP561 AP's to a single point set up cluster that I already have running on 2 x WAP561's. The problem is that whilst the new WAP's accept the cluster name none of the clusters configurations details are updated, such as SSID and security settings.
I have tested this on both new units and have the same result therefore I assume I am missing something rather than hardware issues.
Any advice is welcome.
06-24-2017 10:02 AM
I have exact same problem.
Can anyone help me?
Thanks in advance.
06-26-2017 06:50 AM
I had this same problem. As it turned out the firmware on the newer APs was newer than the old APs. I had to update the firmware on the old APs. Keep in mind, the settings you have in your existing APs will be lost (at least mine were). So I had to start over from scratch. I wrote down all the MAC addresses I had entered.
I hope this helps.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide