Wireless - Small Business

I have several WAP561 (PID VID:WAP561-A-K9 V01) with  firmware 1.0.4.4. It is posible to apply firmware 1.2.1.5 ?

We have 3 WAP121 APs configured as singel Point Setup all seems to work. Today i thought I would check the settings and update FW. But i cant open the web configuration page on any of the 3 APs. Only get timeout. Tried using the IP addresses and Ci...

Hi Community,I have a problem with access point WAP321I have tried to hard reset it but it not responding and when i plug it via ethiernet cable it shows unpluged on my pc the only led working is the power it's flashing and other led not lighting whe...

Hello,I would like assistance with the parameterization of a Cisco SG200-18 switch. Indeed I would like to create three separate VLANs to distribute from the internet to three companies that do not have to interact in it or with my personal network, ...

Hi, For a lab i need to setup a Cisco wap551 in a smal network with cisco router 2921 and cisco catalyste 3650... But when i connect my cisco 551 to any port of my switch after a few seconds the port is deactivated... I have been trying for a week bu...

I am trying to replace a Cisco WAP371 with a WAP571 for my office. I have connected the 571 to the same LAN cable from the switch that is used for the 371, and I have configured it the same as the 371. When I complete the configuration wizard and su...

I want to monitor traffic on wireless device (childrens's tablettes); I already know the mib (SNMPv2-SMI::enterprises.9.6.1.32.4410.1.3.3.3.1.2.1.1 ) to retreive the associated mac adress; but I need to understand how to get the traffic generated for...

Goodday, i have recently purchased a Cisco WAP561 (serial number: DNI1819A0ZA , wired MAC address 189C5D3F32A0) and i have connected it via a Cisco PoE injector (SN: CMS2039ZZE4) and followed the installation guide up to the connection part. The devi...

Hi, We are using 6 number of Cisco WAP121 wireless access point, in which one has given disconnected in between working hours ant the port on PoE switch will be hang. When I change the port on switch, this device will be working fine and again fail i...

I just purchased a Cisco WAP571 access point.  I want to upload a configuration file to the AP to set it up for my network. When I first connect it to the switch and try to configure it, it won't allow me to cancel the setup wizard. When I complete t...

Hi, My customer is having 3 Cisco WAP371, running with the latest firmware 1.3.0.4 Two of them were running in a Cluster made with Single Point Setup and where already rebooting every 3 or 4 days.I've joined the third one into this cluster and it's ...

Is there a limit to the number of wifi devices that can be connected to this Access Point

Hello, The AIR-SAP-1602I-E-K9 is supposed to be replaced by AIR-AP1852I-E-K9C. However, this one does'nt play the role of WorkGroup Bridge ... So I'm looking for a brand new Cisco standalone access point that I can configure as workgroup bridge (or ...