1000 series AP

[zimmermanml]

When a client connects to the wireless network it shows that the 1010 light weight access point is still WEP enabled. The reason I think this is because in the 2006 Wireless LAN Controller under Clients > Detail

AP Properties:

WEP state = WEP enable.

I have WPA/802.11i checked for the WLAN and also WPA/802.11i checked for Trusted AP’s. I am not sure why it still shows that WEP is enabled?

[wong34539]

I think WEP is still enabled on the WLAN controller. If you have enabled the WPA for the APs i guess the configuration is not saved on the controller. Try redoing the configuration and save it and check again. It should work.