Two 1100's are setup as a bridge, both connected to a 1100 running as a root-AP.
A problem occurs when a client leaves the area where the root-AP is and goes to one of the areas where a bridge-AP is providing connectivity:
no traffic is bridged. (Workaround for this issue is a 'clear bridge' command on the bridge-AP)
Bridge configuration:
!
bridge irb
!
interface Dot11Radio0
bridge-group 1
bridge-group 1 spanning-disabled
!
interface FastEthernet0
bridge-group 1
bridge-group 1 spanning-disabled
!
bridge 1 protocol ieee
bridge 1 route ip
!
The root-AP has the following config:
interface Dot11Radio0
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
!
interface FastEthernet0
bridge-group 1
no bridge-group 1 source-learning
bridge-group 1 spanning-disabled
!
bridge 1 route ip
Anyone who can tell me why the bridge is blocking roamed clients?
