Wireless

Hi,we have still this box from Cisco, and we are looking at replacing it.What is the product we should use to replace it? Seems that Cisco now has several options.Jorge

If I use a wireless digital signal to stream music videos, is it possible to be streamed with HD video and 24 bit audio without losing any quality over the transmission? And can it be done with out any wait time to buffer?

I can't find much configuration information regarding PEAP using LWAPP AP's and a 4404 WLC.Any help would be appreciated.

Hello,I am new to Cisco wireless AP, and need help setting up a AP to authenticate clients to a Radius server.Can anyone please post the required configuration for the AP, as well as how to setup the Radius server (installed on Windows 2003 server) t...

On our 3560g switch we have g0/15 set up as a trunk to connect our wireless AP.Port Mode Encapsulation Status Native vlanGi0/15 on 802.1q trunking 35Port Vlans allowed on trunkGi0/15 1-4094Port Vlans allowed and active in management domainGi0/15 1,10...

I'm rolling out a full LWAPP converstion from my current WLSE/WDS environment. Everything is going well, but a few points. What have other folks done with a final fall back solutions?My point is this:We have 9 different campuses, each with anywhere f...

We are receiving numerous CRC errors on the Radio interface for a Cisco 1310. It is a point-to-point bridge connection; both Root and Non-root are generating the errors.Description (Lifetime-Last 5 seconds)Header CRC Errors 15088213-125Protocol Defer...

Hello everyone. I have been searching for documentation from Cisco regarding a secure configuration for Cisco 1300 series bridges. I have viewed the "Cisco IOS Software Configuration Guide for Cisco Aironet 1300 Series Outdoor Access Point/Bridge" (h...

Hi,I didn't find information about the approximate indoor range of AP 1510 with the antenna AIR-ANT5175V-N.Does somebody help me?tks.

hi all,how to config the WLC 4404 with the maximum clients associate on one AP1131ag? If the clients full on one AP,how does the AP do with the latest client associate ? Thanks your answer ~

Hi all.Can you help me to find url or some information about: How many client can connect to a AP in the same time ?I think this number is 20-30 clients per AP, but i can't find the correct information or relational things.Plz, help me.ThanksChung Tr...

Hi,We have a number of 2006 WLC and 1131 LAP's. The LAP's communicate with the WLC, but fail to register fully and constantly reboot. The following is the error message from the debug lwapp events command on the WLC. I have upgraded the WLC's to vers...

We have had several 3com based WLAN's with dual SSID's using 2 methods of authentication - WPA2 & WPA-PSK on each AP. We have had to replace these as they couldn't take the environmental conditions. Is it possible to achieve WPA2 & WPA-PSK on one SSI...

I have flashed the cisco 1200 ap using the upgrade utility. Everything checks out ok but the .csv file is empty.Did i miss something here?DetailsModel:AIR-AP1232AG-S-K9 Autonomous IOS:12.3(7)JA2 Lightweight IOS:c1200-rcvk9w8-tar.123-11JX1