12-14-2009 12:03 PM - edited 07-03-2021 06:21 PM
Hello everyone,
I am new at setting up root and non-root bridges. I am trying to set-up three 1230ag devices.
One as the root and the othe two as non-root, I copied the config txt from the root and
copied that into the two I am going to use for the non-root. That way the ssid's are the
same. When I set the role to non-root the radio is not enabled and I get a message saying
Interface Dot11Radio0,cannot associate:No Response
Does any know what I am doing wrong, and how to fix it
Thanks
12-16-2009 02:20 PM
The radio interface will go down in response to being configured as a non-root bridge, so that much is working. But there must be a configuration error if it won't associate. Can you post the configs so we can review them?
Are the bridges mounted, or are they on your desk?
12-17-2009 08:28 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide