Hi,
I have converted one 1231G into LAP mode and while trying to register same into Cisco WLC, after loading with LAP image (Recovery Image) it giving below mentioned message and getting again its getting rebooted. Also i have noticed that its not taking any command were i can manually point to WLC. Auto reboot is happening within few seconds. Kindly proivde your experience related to similar issue.
*Mar 1 00:00:05.360: %SYS-5-RESTART: System restarted --
Cisco IOS Software, C1200 Software (C1200-RCVK9W8-M), Version 12.3(7)JX9, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by Cisco Systems, Inc.
*Mar 1 00:00:06.315: %LINK-3-UPDOWN: Interface FastEthernet0, changed state to up
*Mar 1 00:00:07.315: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0, changed state to up
*Mar 1 00:00:24.381: %LWAPP-5-CHANGED: LWAPP changed state to DISCOVERY
*Mar 1 00:00:35.103: LWAPP_CLIENT_ERROR_DEBUG: spamHandleDiscoveryTimer : Found the discovery response from MASTER Mwar
*Mar 1 00:00:35.110: %LWAPP-5-CHANGED: LWAPP changed state to JOIN
*Mar 1 00:00:41.110: LWAPP_CLIENT_ERROR_DEBUG: spamHandleJoinTimer: Did not recieve the Join response
*Mar 1 00:00:41.110: LWAPP_CLIENT_ERROR_DEBUG: No more AP manager IP addresses remain.
*Mar 1 00:00:41.110: %SYS-5-RELOAD: Reload requested by LWAPP CLIENT. Reload Reason: DID NOT GET JOIN RESPONSE.
*Mar 1 00:00:41.110: %LWAPP-5-CHANGED: LWAPP changed state to DOWNXmodem file system is available.
