1241 Bridge

[mironduplessis]

Hi,

We are testing 2 1241 Access Points in bridge mode. Essentially we want to enable connect two switches using a pair of access points. The switches will have multiple vlans and thus will

have a trunk to the access point.

We have used other bridges in the past

for this but want to see if it works on

the Cisco AP's.

Does anyone know how this would be accomplished.

Regards

Miron

[pradeepde]

For this setup you need to create VLANs on the APs. Read the following document which will give you information on how to configure the VLANs on AP.

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_example09186a00801d0815.shtml