Wireless

we want to deploy the AP in office, and hope the clients could be secured by a VPN 3005. so we need to connect the AP to VPN 3005. does anybody know how can i configure the AP and the VPN 3005? and how can the clients get the initial IP address to co...

I cannot get a 2006 controller to talk with 1020 AP's. I can get my 1240's to talk no problem, however the 1020's don't want to cooperate.I haven't changed the configuration on the controller, and I am using the same switchports.Thoughts?

Hello,Im having a little issue understanding the Interface layout of the 4402. 1 - Service Interface1 - Utility Interface2 - AP Interfaces that manage 24 AP's per interface(correct?)So I created a VLAN just for internet only traffic. Managment Interf...

Dear Community:I have an interesting problem. We have satellite office with a residential DSL line installed. My customer requested we set up a wireless network to share out the Internet access. Instead of buying a Linksys, I bought four 1130's and a...

Hi, Where I can get the Linux dirvers and how to install in linux system for Cisco wireless PCI card part no (AIR-PI21AG-A-K9)Kind RegardsRanga Kishore9885030063

Hello there I want to know if I can run a query for certain event and get a list of events instead of a report and graph ? now I get only graphs ?

We have a requirement to link two adjacent buildings that are about 20-metres apart over a public road. I need some advice on what the best solution will be.Initial thoughts are a pair of Aironet 1300's configured as Wireless Bridges but the antenna ...

Hi,Network Setup:I have Four sites - Site A, Site B, Site C and Site D. Site A is having Two Antennas - Omni directional (24120) and Unidirectional (3338). Site B & C having 3338 Uni directional antenna is getting connected to Site A in it's Omni dir...

I have a building with over 4000 users and would like to bind multiple VLANs for user access to a single SSID in WLC. Can this be done? I would rather not have 4000 wireless users on a single VLAN.

I'm connecting a 1240AG access point to a Cisco 2960 via 802.1Q trunking. The AP (access point) has a BVI1 interface address of 10.19.28.20/24, and it's default-gate is 10.19.28.1 and DHCP requests are handled by the private network's DHCP server. I ...

Is there a possibility to generate an wireless client detail export including the information from all known clients instead of the single one selected?Perhaps by getting access directly to the db2 via api?