1400 Bridge - Validating Throughput

[kmphilbin]

Hello,

Excuse the newbie question, but I am trying to validate the throughput between a pair of Aironet 1410's. Would using the command:

dot11 dot11radio 0 linktest rate 54 packet-size 1400 count 1500 target <mac address of other end of bridge>

Work for determining throughput, or is that only validating that the packet is transmitted at 54Mbps? If this doesn't tell me throughput, is there a generally accepted method of determining throughput across a bridge?

Thanks,

Kevin

[Scott Fella]

You can use a tool called iperf or use Qcheck to test for throughput.