1572EAC-M Power level issue

[yahya.jaber]

WLC 8500 with 8.0.120.0

I installed one 1572EAC-M AP on power injector.

When I check the power level allowed it's only 3 levels "16, 13, and 10"

The WLC "show country channels support tx-power" it allowes me to use 27dbm on certain channels, why can't I see those?

My country is SA 

Thanks.

[Rasika Nayanajith]

check your regulatory domain restrictions on both 2.4GHz and 5GHz bands.

If regulatory domain allows higher power level for the frequency band AP operate, then it could be a software issue of the 8.0.x code as well.

Refer this thread on similar issue but with different AP model

https://supportforums.cisco.com/discussion/12982941/low-tx-power-levels-cisco-3702i-ap

HTH

Rasika

*** Pls rate all useful responses ***

[yahya.jaber]

my WLC says

show country supported tx-power

27*27*27*27*27*27*27*27*27*27*27*16*16*16*16*

from channel 100 till 161 and my AP channel is 100 80Mhz

i have 3702 AP's and they are having the correct power level.