cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2333
Views
0
Helpful
19
Replies

2.4 GHz. Frequency setting.

alikoca869453
Level 1
Level 1

There are 11 access points in the system. The distance between them is 80 mt. only the difference between 3 of them 450 mt. 2.4 MHz. Signals between operating devices are low. The current frequency settings are as shown in the picture. how the settings should be.

19 Replies 19

marce1000
VIP
VIP

 

 - Don't know why you are using Custom for Rf Channel Assignment and Tx Power Level Assignment - use Global.

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

When global, the signal is low.

I want to learn, antenna gain dbi  and  

I want to learn, antenna gain dbi


 

Why are the channel and power settings statically assigned?
Is ED-RRM enabled?

 

Thanks for answer

This is done because the signal levels of the devices running 2.4 MHz are low.

What is your suggestion?

 

 

What is ED-RRM? how we should make this setting ?


@alikoca869453 wrote:

This is done because the signal levels of the devices running 2.4 MHz are low.


My recommendation is to set the AP's channel selection and power selection to auto. 

Go to RRM and DCA and make sure they are set to auto.

hi 

What should be the antenna gain setting?

aaaaaaaaaaaaaa.jpg

 

Hi

As you say, when I want to change the frequencies in the dca channel list section gives the following error.

aaaaaaaaaaaaaa.jpg

 

 

Hi

dca screen is as follows. What are your suggestions

 

 

aaaaaaaaaaaaaa.jpg

 

 

What AP do you have? Why are you adjusting the antenna gain?
What exactly are you trying to do?

What AP do you have?              AIR-AP1562E-E-K9

 

Why are you adjusting the antenna gain?            Signal levels come low for 2.4mghz devices

 

exactly what I want to do is to raise the signal levels of the devices and ensure that they do not break.

 

a value must be entered here.
What is your suggestion.

Ok, so if you have a 1562E what model of antenna are you using?

AIR-ANT2513P4M-N 13 dbi  (There are 2 units and there is a distance of 800 meters between them.)

 

AIR-ANT2568VG-N 8 dbi    ( There are 8 units and there is a distance of 50 meters between them.

 

 

Have you done any site survey?
How are you measuring the signals provided by the antennas?

Cheers,
Vasco
Review Cisco Networking for a $25 gift card