Hi Folks,
With the advent of 7.4 directly connected APs were supported on the two PoE ports on the 2504 controllers. However, I haven't been able to get this configuration to work, nor have I been able to find sufficient documentation that supports this configuration.
I'm running 8.0.120.0 on my 2504 and have a pair of 1702I that I'd like to attempt in this configuration. I understand it's not going to be a best practice but was hoping to at least do some testing with the configuration in my home lab. I only have a 10/100 PoE switch and haven't picked up any power injectors yet to utilize them on my gigabit non-poe switch.
Has anyone configured this successfully yet?
Thanks,
Derrick
