2602i Led control

[JOHN GRIMM]

Is it possible to control the LED on a 2602i?  It's too bright.

[Rasika Nayanajith]

You can turn it off if that helps. Otherwise I do not think you can control light level. Here is the CLI command to do this for a given AP

(WLC3) >config ap led-state ?

disable        Disables the LED-State for an AP

enable         Enables the LED-State for an AP

(WLC3) >config ap led-state disable ?

all            Applies the configuration to all connected APs.

     Enter the name of the Cisco AP

(WLC3) >config ap led-state disable

HTH

Rasika

**** Pls rate all useful responses ****

[Leo Laohoo]

It's too bright.

Nope.  You can either turning it on, off or flashing.  Your choice.

[Scott Fella]

Turn it off or else put one of these on the light like one of my customers did:)

http://m.staples.com/touch/product.html#67076

Sent from Cisco Technical Support iPhone App