11-01-2013 01:39 PM - edited 07-04-2021 01:11 AM
Is it possible to control the LED on a 2602i? It's too bright.
11-01-2013 01:48 PM
You can turn it off if that helps. Otherwise I do not think you can control light level. Here is the CLI command to do this for a given AP
(WLC3) >config ap led-state ?
disable Disables the LED-State for an AP
enable Enables the LED-State for an AP
(WLC3) >config ap led-state disable ?
all Applies the configuration to all connected APs.
(WLC3) >config ap led-state disable
HTH
Rasika
**** Pls rate all useful responses ****
11-01-2013 08:16 PM
It's too bright.
Nope. You can either turning it on, off or flashing. Your choice.
11-02-2013 04:14 PM
Turn it off or else put one of these on the light like one of my customers did:)
http://m.staples.com/touch/product.html#67076
Sent from Cisco Technical Support iPhone App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: