2802i 5Ghz Radio not broadcasting

[JafferStroks]

Im trying to setup a 2802i to do a AP on a Stick Survey. I converted the AP to Mobility Express 8.10.152. I went through a fresh setup and assigned an SSID to both radios. It is only broadcasting from the 2.4.

I tried creating a new SSID and assigned it to the 5Ghz radio and still see nothing in the air.

I even deleted all WLANs and created one just on the 5GHz radio and no luck.

I have factory reset it at least 3 times and did all the same things and no luck.

When i run the show advanced 802.11a txpower it shows the radio enabled and at the power level I set in the GUI.

I can change the power level in the GUI and see it change from the cli.

No idea what is going on with it so any suggestions would be hugely appreciated.

[Arshad Safrulla]

Nothing can be said without having a look in to the show commands and OTA captures. But by the looks of it sounds more like a hardware issue, is it possible to get TAC check this?

[marce1000]

 - Reboot the AP , and check the logs just after startup , you may find more info's related to this problem.

 M.