I have a BR-340 bridge operating in bridge mode. This is one of the original units shipped right after Cisco took over Aironet but has been upgraded with the latest firmware.
Works fine for several days and then loses association and has blinking red light. The logs say: "Unable to determine radio type !". A reset does not fix this and it must be powered down for a few minutes and re-booted. Then it will work for a few more days.
Can anyone help with a clue here? Is this a hardware problem? Is this unit not compatible with the latest firmware? Does anyone have an old BR-340 image I could reload to this unit to test?
Thanks in advance for any assistance.
Ron Curry
rec@curry.org