02-26-2017 01:11 AM - edited 07-05-2021 06:36 AM
hi Team,
Cisco AP 3802 joined but shows admin state disabled ? need to enable manually any idea why ?
firmware 8.2.141
Thanks
shiju
02-26-2017 04:30 AM
Need a little bit more info
Is this a new install? You have other AP's on this controller that is working fine? Is this just one AP or all your 3802's? Mobility Express or controller?
-Scott
*** Please rate helpful posts ***
02-26-2017 05:05 AM
Yes, ts a new install and all 3802s are is same disabled adminstate, I have manually enable it.
other APs are working fine. controller 8540
Thanks a lot for your reply.
02-26-2017 06:59 AM
Is it Mobility Express or controller? I know if you use the out of box feature, it would disable the AP state and when you move the AP to a new group, you still need to enable the AP state.
-Scott
*** Please rate helpful posts ***
02-26-2017 11:06 PM
Thanks for the reply, its controller 8540, out of the box feature is not enabled.
luks like its bug.
Thanks
02-26-2017 11:08 PM
It most likely is.
-Scott
*** Please rate helpful posts ***
02-26-2017 11:36 PM
Thanks, I will proceed in that direction
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide