07-26-2007 04:49 AM - edited 07-03-2021 02:24 PM
I have both interfaces setup as lag, connected on different switch cards on the same switch.
In the switch logs, it is returning errors that the host is flapping. Is there something I have configured incorrectly, or is that expected behavior due to the LAG setup.
07-26-2007 05:56 AM
Hi Friend,
Just want to make sure after you enabled LAG on controller, have you reloaded the controller once?
Also I believe you must be using Cisco SFP modules installed on your WLC?
Have you also configured etherchannel group on your switch and make sure both the ports have exactly same config.
Regards,
Ankur
*Pls rate all helpfull post
07-26-2007 07:10 AM
Yes, the controller has been restarted.
Yes, they are SFP modules.
No, I don't think an etherchannel group is setup with those two ports.
07-26-2007 07:25 AM
Hi Friend,
So there is the problem. If you do not have etherchannel configured on your switch side then it will create a loop and flapping message are very obvious in this case.
Configure the 2 ports as a part of sam channel group and it will resolve your issue.
Something like this
Switch(config)#interface
Switch(config-if)#channel-group
Switch(config-if)#interface
Switch(config-if)#channel-group
I have posted a config specific for etherchannel you interface can have other configs also like vlans and other stuff but make sure both the ports have same configs.
HTH
Ankur
*Pls rate all helpfull post
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide