Wireless

I have a couple 2811 routers with the internal WLCM and I don't have a clue what the username and password are. I've tried using the command "service wlan 1/0 reset" but that gets me nowhere. I've even tried "Reset-config" as the username and that do...

I'm sure I'm not the first to ask but I can't seem to find an answer anywhere. I have a point-to-point link with 1310 bridges and external 10dBi YAgi antennas. The distance is 4.47km and the user experience is poor. I don't have the enable password a...

I am trying to use an AP1231G as a wireless bridge to a non-cisco AP (linksys router) for an ethernet device that is not wireless capable. The AP1231 is running the latest IOS version.This is a standard 802.11g network with 128WEP. Yes I know it's ...

I have a ACS Appliance 4.1, I want use MAB (MAC Authentication Bypass) for authentication VPN users base on MAC Address (only PC has MAC in ACS can have VPN connection) but I have several problems:+ Can't Install CA in ACS+ not found out the Private...

I was trying to setup user authentication via EAP with ACS server. what I did is just follow the configure of the url:http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_example09186a00801bd035.shtmlPlease check my AP config...

Hi,We have combination of 350 and 1200 APs in our wireless setup and we are using WPA with LEAP/PEAP with ACS 3.2. User authentication is via RADIUS and APs authentication is via TACACS+. Recently I've made few changes in APs which are:1) Upgraded fi...

Hi All,Could some please send me a basic config for for two wireless points setup as a root and non-root.Cheers

I want to use 2 1310 APs as trunk links between switches. I have 1 set as root-bridge and the other as non-root. The non-root stays in the reset state on the dot11radio0 and does not connect. What causes it to go into that state?? I have configured ...

We just got a Think Pad that we can get to connect to our secure network. The laptop will connect to our open network.The laptop has Vista Ultimate software and an Intel wireless connection. We can not get an IP address on the secure network. A/P 12...

I have a WCS v 4.0.96 which controls 3 WLC boxes. Suffice it to say there have been too many hands in the WLC making changes. How do I go about synchronizing my WCS to the controllers to make sure they all are in agreement with each other?

Hello,I have a Cisco 1841 router and a HWIC-AP-AG-A card. I have tried installing the HWIC card in the 1841 router and I get an error stating that there is an unknown daughter card in the slot. I also tried the card in a 2821 router and I still get ...

I have a few new aeroscout RFID tags that I was told would work with Cisco LWAPP/Location. I don't see them connected but they are powered up. I was told you needed to buy software to configure the tags for advanced settings but they would also wor...