07-10-2019 10:09 AM - edited 07-05-2021 10:41 AM
I was able to setup and get my WLC setup, but then it fails to put a ip address on it. The port shows activity, but does not have any clients show up on the server. Any idea's?
07-10-2019 09:59 PM
if i understand you correctly!!!!!
you setup the WLC but cant set the WLC managemnent ip on it?
paste the outout of the these commands
from WLC: sh interface detail management
from swicth: sh run int po <int - where wlc is connected>
Regards
Dont forget to rate helpful posts
07-11-2019 12:12 PM
Interface Name................................... management
MAC Address...................................... 00:21:d8:1e:d4:20
IP Address....................................... 10.10.80.3
IP Netmask....................................... 255.255.255.0
IP Gateway....................................... 10.10.80.1
External NAT IP State............................ Disabled
External NAT IP Address.......................... 0.0.0.0
VLAN............................................. 10
Quarantine-vlan.................................. 0
Active Physical Port............................. 1
Primary Physical Port............................ 1
Backup Physical Port............................. Unconfigured
Primary DHCP Server.............................. 10.10.80.5
Secondary DHCP Server............................ Unconfigured
DHCP Option 82................................... Disabled
ACL.............................................. Unconfigured
AP Manager....................................... No
Guest Interface.................................. No
L2 Multicast..................................... Disabled
07-11-2019 12:15 AM
07-11-2019 12:14 PM
an ip config showed
Active Physical Port............................. 1
Primary Physical Port............................ 1
Backup Physical Port............................. Unconfigured
Primary DHCP Server.............................. 10.10.80.5
Secondary DHCP Server............................ Unconfigured
DHCP Option 82................................... Disabled
ACL.............................................. Unconfigured
AP Manager....................................... No
Guest Interface.................................. No
L2 Multicast..................................... Disabled
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide