4x4 MIMO

[Jorge Emmanuel Hidalgo Vega]

Hello

Guys

I have an antenna 3702i of Cisco.

The problem is this:

How can I know 4 Tx and 4 Rx Antennas  works in Access Point?? , I think that exists a command or something like this.

Thank you so much for your answer

Regards

[Rasika Nayanajith · Accepted solution]

Hi

If you get the "show controllers dot11radio x" output you can verify that 4-RX & 4-Tx antenna being used.

Configured TxPower:             23 dBm (Level Index 1)
Allowed Power Levels:           23 20 17 14 11  8  5  2  dBm
Allowed Client Power Levels:    23 20 17 14 11  8  5  2  dBm
Antenna:                        Rx[a b c d ]
                                Tx[a b c d  cck all ofdm all]
                                Internal

TEST-AP#sh controllers dot11Radio 1

Configured TxPower:             11 dBm (Level Index 5)
Allowed Power Levels:           23 20 17 14 11  8  5  2  dBm
Allowed Client Power Levels:    23 20 17 14 11  8  5  2  dBm
Antenna:                        Rx[a b c d ]
                                Tx[a b c d  ofdm all]
                                Internal

HTH

Rasika

**** Pls rate all useful responses ****

[Jorge Emmanuel Hidalgo Vega]

Thanks for your answer Manannalage ras =D