Hi,
I have a 5508 controller connected to a 6500 VSS pair. Below is the port channel configuration and port configuration. I am just wondering whether we still have to configure a load balancing method as cisco recommends “port-channel load-balance src-dst-ip” as best practice.
Does this still applicable for 5508 controller-6500 Series uplink as the etherchannel is L2 etherchannel?
Port Channel Config:
interface Port-channel1
description To 5508 WLC
switchport
switchport trunk encapsulation dot1q
switchport trunk native vlan 9
switchport trunk allowed vlan 10,11,12
switchport mode trunk
mls qos trust dscp
end
Interface Config:
interface GigabitEthernet1/1/42
description To 5508 WLC
switchport
switchport trunk encapsulation dot1q
switchport trunk native vlan 9
switchport trunk allowed vlan 10,11,12
switchport mode trunk
wrr-queue bandwidth 5 25 70
wrr-queue queue-limit 5 25 40
wrr-queue random-detect min-threshold 1 80 100 100 100 100 100 100 100
wrr-queue random-detect min-threshold 2 80 100 100 100 100 100 100 100
wrr-queue random-detect min-threshold 3 50 60 70 80 90 100 100 100
wrr-queue random-detect max-threshold 1 100 100 100 100 100 100 100 100
wrr-queue random-detect max-threshold 2 100 100 100 100 100 100 100 100
wrr-queue random-detect max-threshold 3 60 70 80 90 100 100 100 100
wrr-queue cos-map 1 1 1
wrr-queue cos-map 2 1 0
wrr-queue cos-map 3 1 4
wrr-queue cos-map 3 2 2
wrr-queue cos-map 3 3 3
wrr-queue cos-map 3 4 6
wrr-queue cos-map 3 5 7
mls qos trust dscp
channel-group 1 mode on
end
