802.11d on WLC4404 controllers and LAPs
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-01-2008 11:40 AM - edited 07-03-2021 04:06 PM
We run 2 WLC4404 and 1 WLC4402 controllers (ver 5.0.148.0), with mostly air-lap1242ag ap's. A vendor REQUIRES that we use/enable 802.11d world mode on our APs, and I am having trouble finding if our setup will handle this standard. Our WCS system reports we are using IOS ver 12.4(13d)JA on the lightweight APs.
Can anyone verify that our current setup supports 802.11d, and also tell me how to enable it on controllers/waps? Thanks-
- Labels:
-
Other Wireless Topics
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-01-2008 08:31 PM
You might want to look at this:
Enabling Dynamic Transmit Power Control
When you enable Dynamic Transmit Power Control (DTPC), access points add channel and transmit power information to beacons. (On access points that run Cisco IOS software, this feature is called world mode.) Client devices using DTPC receive the information and adjust their settings automatically. For example, a client device used primarily in Japan could rely on DTPC to adjust its channel and power settings automatically when it travels to Italy and joins a network there. DTPC is enabled by default.
Enter this command to disable or enable DTPC:
config {802.11a | 802.11bg} dtpc {enable | disable}
*** Please rate helpful posts ***
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-02-2008 04:32 AM
Thanks Fella5. I have verified that dtpc is enabled on our 802.11a/b power status parameters. Especially helpful that text said dtpc is same as world-mode on autonymous IOS aps.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-02-2008 04:34 AM
Glad to help.
*** Please rate helpful posts ***
