Wireless

Hi,There is no L3 network connection to some of the 1522 APs in our mesh network.They register with the 4402 WLC (5.2.157.0)i.e. appear in the AP list. When sending ping packet to APs IP addresses from WLC or PC there is no response, but I can see AP...

I am trying to generate a certificate for PEAP authentications for my Aironet 1250.  The CA is a MS Stand alone CA.  I get the following error in my event log on the IAS server.Could not retrieve the Remote Access Server's certificate du to the follo...

Dear all,I'm experiencing an issue with wireless guest, when accessing a site with https, the traffic is not intercepted by my controller, http sites are intercepted without any issue, I've found a document where this issue is mentioned as bug ID CSC...

Hi I have takken over a running ASA with a ASA-SSM-20 but nowhere can i find the passwordand the asa is running 8.0.3 but the SSM is only running 5.1so the command hw-module module x password-reset dosn't workanybody there have an idea how to fix itt...

hi,If we have two SSID configured on 1100 series Access Point is it possible to stop or hide broadcast of one SSID by "no guest-mode" command and allow broadcast of other SSID with guest-mode command?Please share the experience.ThanksSubodh

HII'm led to believe that the WCS controls the Channel and power issue for the APS. We are using image    WCS      5.2.1.148WiSMs – 5.2.193 Triangulated coverage. Several APs are using the same channel over lapping each other and using TX Power 1 whe...

Hi,We would like create guests accounts active everywhere in campus. The problem is that the WCS want a single building and don't accept the "none" building (see attachment). Thanks in advance.Joel

Hello,I am trying to setup the Sponsor Groups tied to AD groups. I have the NGS connected to the AD, however all a portion of the Groups from AD are populating the pulldown menu. As a add more Domain Controllers more groups are added but still not al...

Hi, has anyone seen this behavior? with a WLC 5500, V 6.0.188, guest users work just fine on the LAN, but, if a guest user on an H-REAP AP tries to connect to this wlan, it won't get an IP Address, it's not configured H-REAP local switching for this ...

I have just upgraded to Version 12.3(8)JED and now for some reason it won't accept my credentials via http access.The Telnet access does work though.I am not sure what could be the problem.

Hi can anyone tell me if the WET610N bridge is supported by the cisco wireless unified network? in plain english can I connect the linksys WET610N bridge to a LWAP 1242?RegardsTyrone

Hi,Anyone aware of any changes to RRM defaults or the RRM algorithm in 6.0.188.0 from 6.0.182.0?  I re-read the release notes and don't see anything that seems relevant...I upgraded a couple 5508s over the weekend and have had 321 channel changes (70...