8510 WLC---Error Code being displayed on the pullout Diag Panel:::

[Rob Johnson]

PCI Light is illuminated w/ code 26 being displayed.

I've looked and looked but can't find what the hec it is.

Any ideas out there anyone?

thanks, rob

Figure 1-5     Light Path Diagnostics Panel Components

[Richard Wakefield]

Having a decoder for these would sure be nice... 6D is what? 00 is good?

[jcjordana]

Hi guys,  I have similar problem in 8510 WLC---Error Code being displayed on the pullout Diag Panel:::, The code is: F.4.

I attached the image,

thkns

Julio Jordan

[jagan.chowdam]

Its not the exact answer to your question, but Table 1-1 Light path diagnostics panel LEDs from the following URL has information about the Error codes on the 8510 WLC.

https://www.cisco.com/c/en/us/td/docs/wireless/controller/8500/install/guide/ctrl8500/ctrl8500main.html

***Please rate all helpful responses***

Jagan

[jcjordana]

Hia Jagan, thanks for you links, in said links, there is no detailed information of the code.

Julio.

[Haydn Andrews]

The box that the code is displaying in is called the Checkpoint code display: This display provides a checkpoint code that indicates the point at which the system stopped during the boot block and POST. A checkpoint code is either a byte or a word value that is produced by UEFI. The display does not provide error codes or suggest components to be replaced.

I would contact TAC with the code being displayed and they will be able to advise what is wrong and help