9124 CAPWAP Failure

[jtpntx]

Trying to get it to boot to ROMMON. Holding button, release @ 20-30 sec, hit ESC....DOES NOT WORK.

[Mark Elsen]

  - @jtpntx    Post the boot process , or what's left from it after holding the mode button.
                    Provide background details of the original issue too and what leads you to the current actions taken

  M.

[jtpntx]

The short version

Wait for the button to be released ....
Button pressed for 36 seconds

Setting env for full reset..
Writing to Nand...
Erasing block 0x728000
Erasing at 0x72f000 -- 100% complete.
done
Auto boot mode, use bootipq directly
APPS power cycled and restart reason is 0x10
Hit ESC key to stop autoboot: 0
Specified BOOT: part1
ubi0: attaching mtd2
ubi0: scanning is finished
+-------------------------------+
| part1: 1650 PEBs|
| part2: 2300 PEBs|
+-------------------------------+
ubi0: attached mtd2 (name "mtd=0", size 1024 MiB)
ubi0: PEB size: 262144 bytes (256 KiB), LEB size: 253952 bytes
ubi0: min./max. I/O unit sizes: 4096/4096, sub-page size 4096
ubi0: VID header offset: 4096 (aligned 4096), data offset: 8192
ubi0: good PEBs: 4092, bad PEBs: 4, corrupted PEBs: 0
ubi0: user volume: 2, internal volumes: 1, max. volumes count: 128
ubi0: max/mean erase counter: 5/3, WL threshold: 4096, image sequence number: 1717526225
ubi0: available PEBs: 62, total reserved PEBs: 4030, PEBs reserved for bad PEB handling: 76

Booting from part1

Loading file 'part1/part.bin' to addr 0x54000000...

[Mark Elsen]

   - @jtpntx                I need the full version ,

  M.

[Leo Laohoo]

---

@jtpntx wrote:
Hit ESC key to stop autoboot: 0

---

This is no ROMMON with Cheetah OS.  

Once this part comes up, hit the ESC key within 5 seconds and the AP will drop into u-boot.

[jtpntx]

I think we strayed here.
I have a C9124AXD-B AP that I need to boot Rommon mode in an effort to fix a problem.
Hitting esc while consoled to the AP doesn't seem to work.
Looking for any info specific to this process to verify steps.

[Mark Elsen]

  - @jtpntx                    Describe the problem (first) ;  possibly there are other ways to fix it

  M.

[jtpntx]

AP flashes green, red amber continuous dispite repeated factory reset. 
Instructions to fix this requires ROMMON boot.

[Mark Elsen]

  - @jtpntx       Instructions are wrong , that only means that the AP is not getting sufficient power ,

  M.