cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
642
Views
20
Helpful
2
Replies

9800WLCs copy config from lab

Saiganesh
Level 1
Level 1

Hello there

   We are trying to migrate WLCs 9800s ACS TACACS+ to Cisco ISE. 

We were successful in migrating in the lab, but we have issues while on the actual production, is there a method to copy the lab configurations to the actual production. in simple word is it possible to copy the wlc config to another wlc.

1 Accepted Solution

Accepted Solutions

marce1000
VIP
VIP

 

 Ref : https://www.cisco.com/c/en/us/products/collateral/wireless/catalyst-9800-series-wireless-controllers/guide-c07-743627.html

                                Take note of the paragraphConfiguration file management

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

View solution in original post

2 Replies 2

marce1000
VIP
VIP

 

 Ref : https://www.cisco.com/c/en/us/products/collateral/wireless/catalyst-9800-series-wireless-controllers/guide-c07-743627.html

                                Take note of the paragraphConfiguration file management

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

Saiganesh
Level 1
Level 1

Thank you this was very useful

Review Cisco Networking for a $25 gift card