Hi
I flow record consists of below fields .. these dont include client IP specifically.
Flow Record Field | Value |
Source IP address | 192.168.10.1 |
Destination IP address | 93.184.216.34 |
Source port | 17238 |
Destination port | 80 |
Protocol | TCP |
Depending on the version of NetFlow, the router can also gather additional information, such as type of service (ToS) byte, differentiated services code point (DSCP), the device’s input interface, TCP flags, byte counters, and start and end times.
Flexible NetFlow, Cisco’s next-generation NetFlow, can track a wide range of Layer 2, IPv4, and IPv6 flow information, such as the following:
Source and destination MAC addresses
Source and destination IPv4 or IPv6 addresses
Source and destination ports
ToS
DSCP
Packet and byte counts
Flow timestamps
Input and output interface numbers
TCP flags and encapsulated protocol (TCP/UDP) and individual TCP flags
Sections of a packet for deep packet inspection
All fields in an IPv4 header, including IP-ID and TTL
All fields in an IPv6 header, including Flow Label and Option Header
Routing information, such as next-hop address, source autonomous system number (ASN), destination ASN, source prefix mask, destination prefix mask, Border Gateway Protocol (BGP) next hop, and BGP policy accounting traffic index
NetFlow protocol data units (PDUs), also referred to as flow records, are generated and sent to a NetFlow collector after the flow concludes or expires (times out).
http://www.ciscopress.com/articles/article.asp?p=2812391&seqNum=2
Hope that helps.