About Configuring the C9105AXW Downlink Interface

[Translator]

3 X 10/100/1000 Base-T (Ethernet) Downlink Interfaces (LAN1, LAN2, LAN3)
To perform a link-up check for,
The "show ip int brief administratively down" command indicates that the status
It's there.
The "no shutdown" command changes the status of each downlink interface to the "down" state
I typed the "configuration terminal" command.
Not supported.

Please check the following.

Downlink interfaces (LAN1, LAN2, LAN3)
To Set the Status Display from administratively down to down
Please teach the procedure.

--------------- Excerpt Log ---------------
AP0CD5.D3CF.A6C8#show ip int brief
Interface IP-Address Method Status Protocol
Speed Duplex
wired0 unassigned unset up up
1000 full
wired1 n/a n/a administratively down down
n/a n/a
wired2 n/a n/a administratively down down
n/a n/a
wired3 n/a n/a administratively down down
n/a n/a
auxiliary-client unassigned unset up up
n/a n/a
apr0v0 n/a n/a administatively down down
n/a n/a
apr1v0 n/a n/a administatively down down
n/a n/a
AP0CD5.D3CF.A6C8#

[Translator · Accepted solution]

If you look at the following document, there is an example output showing LAN1, LAN2, LAN3
Are there any potential ports for Remote LAN (RLAN) solutions?

Cisco Catalyst 9800 Series Wireless Controller (Cisco IOS XE Gibraltar 16.10.x) Software Configuration Guide - Remote LAN [Cisco Catalyst 9800 Series Wireless Controller] - Cisco
https://www.cisco.com/c/ja_jp/td/docs/wireless/controller/9800/config-guide/b_wl_16_10_cg/b_wl_16_10_cg_chapter_01100100.html

To view the LAN port settings for Cisco AP, use the following command:

Device# show ap name <ap_name> lan port summary
LAN Port status for AP L2_1815w_1
Port ID status vlanId poe
---------------------------------------------
LAN1 Enabled 20 Disabled
LAN2 Enabled 20 NA
LAN3 Disabled 0 NA

※ The above command is executed on the WLC side.

[Translator]

To Those Who Answer

Thank you for your interest in related materials. 　

I understand that the destination port needs to be run on the WLC side. (I mistook it as something that can be set on each port like a Catalyst switch.) )