Access point cisco air-cap2702i-a-k9

[AmmarHermiz14196]

Hi, 

I have 2 of the access point Cisco air-CAP2702i-A-k9 working fine, So I bought a third one. 

Can someone please tell me how to copy the configuration from the once I have and paste it in new one?

Thank you!

[Scott Fella]

One thing also, it might be a good idea to export the configuration of the new and an existing and use a diff tool like Meld to see if all the configurations are alike. Sometimes with copy paste, the order is different or the paste happens too fast and line items gets missed or errors out.

[AmmarHermiz14196]

it happened so many time yesterday with coping and paste! you copy something and it paste something else. I was doing it literally line by line.

after that got everything pasted. didn't work then i realized the Radio (0,1) were down so turned them on.but I realized on the exiting once the Protocol are down and the status are up,  the one i did i have everything up status and protocol. I don't know if the Protocol should be shutdown or its fine ?

Thank you Scott!!    

[Scott Fella]

It's hard to say without seeing it, but if its working then that is good.  One thing also is that if the code is different, sometimes the configuration lines are applied in different sections which can also be an issue.  You should look in the down status as that means the interface is not functioning.

[AmmarHermiz14196]

Also I am using Putty and when i am typing in CLI it comes up different letters for instants typing my name Hermiz it will comes up hEjmis

so trying multiple time until get it right. do you know what causes that ?   

I did download Meld now i will compare the config i should have one thing different is the ip addresses

Thank you!

[Scott Fella]

You need to make sure that your laptop or device is configured for 10.0.0.2 (static) and make sure the AP has the 10.0.0.1 ip address.  The firewall on your laptop should be disabled for this and make sure you can ping from your laptop to your ap and vice versa.

[Scott Fella]

That is correct.  Since this would be new, issue the following and copy the basic configuration just in case:

terminal length 0

show running-config

This way you can compare later what has also changed.

[AmmarHermiz14196]

So on the AP, change the terminal length to 0 ?