Solved: Access Point MR-44

yramirezs · ‎06-23-2023

Good morning, to connect 6 MR44 Access Points without the need for PoE power, what MS Switch could you propose?

aleabrahao · ‎06-23-2023

You need to calculate it. For example 740W divided 30W (PoE+) = 24

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

View solution in original post

aleabrahao · ‎06-23-2023

Check it at the documentation.

https://meraki.cisco.com/product-collateral/ms-family-datasheet/

You can use a power injector too.

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

yramirezs · ‎06-23-2023

¿Cuántos puertos máximos admite PoE+ en el Switch MS120-24P y MS120-8FP?

aleabrahao · ‎06-23-2023

You need to calculate it. For example 740W divided 30W (PoE+) = 24

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

decassuncao · ‎06-23-2023

At least .af PoE

Philip D'Ath · ‎06-25-2023

Note that although the MR44 will run on 802.3af (15.4W) the MR44 will retard its functionality. To get all the capabilities you need 802.3at power.