11-12-2009 10:52 AM - edited 07-03-2021 06:15 PM
Hi.
I read CWCS Configuration Guide release 5.1 about ACL, applied ACL to WLAN, but didn't work.
I want to restrict wireless client access any networks.
If anyone knows, please help me.
Thks.
Paulo MaurÃcio
Solved! Go to Solution.
11-12-2009 11:15 AM
Keep in mind with ACLs on the controller they are written with the assumption that you are on the controller and traffic is coming from the wireless clients in regards to the inbound and outbound directions. Also you need to write an inbound and outbound rule for each condition. They aren't like IOS ACLs that will automatically allow the return traffic through.
http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00807810d1.shtml
11-12-2009 11:15 AM
Keep in mind with ACLs on the controller they are written with the assumption that you are on the controller and traffic is coming from the wireless clients in regards to the inbound and outbound directions. Also you need to write an inbound and outbound rule for each condition. They aren't like IOS ACLs that will automatically allow the return traffic through.
http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00807810d1.shtml
11-12-2009 11:41 AM
Thks for help.
I will test.
11-13-2009 06:44 AM
Ok, it works!!!
I found the error. I was configuring by WCS, and when I configured protocol to ANY, returned this message: Protocol : 256 : Value for this attribute is invalid. (Valid Range: is 0 <> 255 )
My WCS version is Version 5.1.64.0, and controller software version is 4.2.112.0.
Thks for help.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide