Wireless

GentsI 2 WISMs and 2 4402 controllers. the WiSM are the foreign controllers and the 4402 are my anchor controllers. I am trying to add them to the WCS for management purposes. however, I am not able. knowing that I have ICMP reachability between all ...

I've been playing with this new Cisco Aironet 1252 Access Point and it's pretty cool.My question to you guys is, when I set up an ssid and enable my dot11 radio 0 interface, I go to view my wireless networks in Windows XP and the SSID I have configur...

Hi, what is the best practices in this case. Use wired data and wireless data in the same vlan? or use differents vlans for wired and wireless data connections?I have this doubt but a think that the correct is use on vlan for each, wired and wireless...

I'd like to know on how can i set up the intergration between the controllers and the tacacs server.i have created a group in ACS as per the controller doc and also added the tacacs server on the controller under: Security Tab, then Tacacs, and i've ...

We have two WLC'2 4402(sw 5.2.193.0) and one WCS with sw 5.2.148.0. I have a lot of client warnings in the controllers trap logs but none clients alarms on my WCS. Is there any reason why the WCS does not reports client problems ?

Hi, i want to configure the WPA2-PSK. what is the way to configure it on 1100 series AP. I have different options like TKIP, AES CCMP with combination of wep128/40 bit. which is the corrent combination for WPA2-PSK standard?

Greetings,After a site survey the number of 1131's is 50% more than our vendor initially recommended, even though they had the floor plans and construction info (concrete building). I understand N AP's have better coverage/penetration. Is it easy for...

I am trying to connect communication between 2 buildings. In the main building, I have a Cisco aironet 1100 connected to the wired Lan. In the other building I am trying to install a Cisco 1242AG. I am in the setup interface of the 1242Ag under the s...

I am working on Guest WLAN deployment using a anchor WLC and NAC Guest Access server for authentication. I now have a requirement to prevent Guest machines from logging in with the same set of credentials. I already have concurrent connections set to...

Hi,I have two 1522 APs and able to associate to WLC4402 successfully via wire but cannot wireless communication from one of AP1522 which changed the role to MAP and disconnect wire.Advise please the configuration steps or CCO URL.Thanks in advance,

I'll keep this as short as possible. I have a couple hundred 1131AG APs deployed with WiSM controllers. Controllers and APs are running 5.1.151.0. The environment has been stable for over a year. We recently had to make some changes which required us...

Hi,Has anybody been able to successfully get a Zebra printer QL420 Plus connected to Cisco LWAPP/CAPWAP APs ?We are using WPA2 - PEAP with Verisign Signed Server Certificate.