ACL on flexconnect APs?

[Daniel Parker]

I previously setup some access control list to block access to certain areas which was tested and worked fine.

Part of a Wi-Fi expansion project required me to switch over to Flex connect mode on the AP's to allow centralised management.

However since the change my ACLs no longer work. I attempted to setup a Flexconnect ACL but afterwards clients were unable to obtain IP's (FC ACL rules mirror my original ACL which worked fine)

any advise would be much appreciated.

[Rasika Nayanajith · Accepted solution]

Hi Daniel,

Are you doing FlexConnect local switching ?

If so, best place to apply ACL is L3 SVI of brach switch for a given wireless user VLAN.

HTH

Rasika

**** Pls rate all useful responses ****