08-18-2009 11:34 AM - edited 07-03-2021 05:57 PM
We are testing ACS 5 with Cisco and Juniper switches. Everything is working well, except we need to use a certain Juniper RADIUS attribute for downloadable filters (think downloadable ACL). The attribute is not listed in the ACS -> Config -> Dictionaries -> Protocols -> RADIUS -> Juniper section, and I cannot see a way of adding/editing the dictionary.
Any ideas?
08-19-2009 04:22 AM
I've also tested ACS5 a while ago with Cisco, HP, and other manufacturers...
Unfortuinaltely that's one of the points where ACS 5 is not yet mature...
Attribute addition is not yet supported, but will definitely be in roadmap.
There was an ask the expert event a few months ago about ACS5. You might want to take a look at that.
Best of luck
Gustavo Novais
08-19-2009 07:13 AM
I believe ACS 5.1 will have this feature, ACS 5.0 is limited in this regards. If this can not wait, you may use ACS 4.2
08-19-2009 12:48 PM
Thank you both for the replies. I'll check out the Ask the Expert, and I am now loading up ACS 4.2 eval to check it out. Looks like CSUtil.exe and I are going to get very chummy.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: